World Marketing of America KWN195 用户手册
15
TROUBLESHOOTING
Continued
OBSERVED PROBLEM
Burner(s) does not light after
ODS/pilot is lit.
ODS/pilot is lit.
Delayed ignition of burner(s).
Burner backfiring during combustion.
Burner plaque(s) does not glow.
Slight smoke or odor during
initial operation.
initial operation.
Heater produces clicking/ticking
noise just after burner is lit or
shut off.
noise just after burner is lit or
shut off.
White powder residue forming within
burner box or on adjacent
walls or furniture.
burner box or on adjacent
walls or furniture.
POSSIBLE CAUSE
1. Burner orifice is clogged.
2. Burner orifice diameter is too small.
3. Inlet gas pressure is too low.
3. Inlet gas pressure is too low.
1. Manifold pressure is too low.
2. Burner orifice is clogged.
2. Burner orifice is clogged.
1. Burner orifice is clogged or
damaged.
damaged.
2. Burner is damaged.
3. Gas regulator is defective.
3. Gas regulator is defective.
1. Plaque is damaged.
2. Inlet gas pressure is too low.
2. Inlet gas pressure is too low.
3. Control knob set between locked
positions.
positions.
1. Residues from manufacturing
processes.
processes.
1. Metal is expanding while heating
or contracting while cooling.
or contracting while cooling.
1. When heated the vapors from
furniture polish, wax, carpet
cleaners, etc. turn into white
powder residue.
furniture polish, wax, carpet
cleaners, etc. turn into white
powder residue.
REMEDY
1. Clean burner orifice (see Cleaning
and Maintenance, Page 13) or
replace burner orifice.
2. Replace burner orifice.
3. Contact local natural gas company.
and Maintenance, Page 13) or
replace burner orifice.
2. Replace burner orifice.
3. Contact local natural gas company.
1. Contact local natural gas company.
2. Clean burner (see
2. Clean burner (see
Cleaning and
Maintenance
, Page 13) or replace
burner orifice.
1. Clean burner orifice (see Cleaning
and Maintenance, Page 13) or
replace.
2. Replace burner.
3. Replace gas regulator.
and Maintenance, Page 13) or
replace.
2. Replace burner.
3. Replace gas regulator.
1. Replace burner.
2. Contact local natural gas company.
2. Contact local natural gas company.
3. Turn control knob until it locks at
desired setting.
desired setting.
1. Problem will stop after a few hours
of operation.
of operation.
1. This is common with most
heaters. if noise is excessive,
contact qualified service person.
heaters. if noise is excessive,
contact qualified service person.
1. Turn heater off when using
furniture polish, wax. carpet
cleaner or similar products.
furniture polish, wax. carpet
cleaner or similar products.