Suunto D6I 用户指南
When there is no stored code, the Suunto D6i displays “cd:--” and receives data with
lowered sensitivity from a very short distance only (0.1–0.5m / 0.5–1 ft). The flash
symbol is not displayed at this phase. By taking the Suunto D6i unit close to the
transmitter, it will store the received code and start receiving with full sensitivity and
display data received with this code only.
lowered sensitivity from a very short distance only (0.1–0.5m / 0.5–1 ft). The flash
symbol is not displayed at this phase. By taking the Suunto D6i unit close to the
transmitter, it will store the received code and start receiving with full sensitivity and
display data received with this code only.
NOTE
The pairing procedure only needs to be performed once, be-
fore the first use. You do not need to redo the pairing unless
you change the transmitter to a new one, or another diver in
your group uses the same code as you.
fore the first use. You do not need to redo the pairing unless
you change the transmitter to a new one, or another diver in
your group uses the same code as you.
To pair the transmitter and the Suunto D6i dive computer:
1.
1.
Ensure that the transmitter is properly attached to the regulator’s HP port and
that the regulator is properly attached to the cylinder.
that the regulator is properly attached to the cylinder.
2.
Ensure that the D6i is turned on, and that the wireless integration is enabled in
the Suunto D6i settings (Tank Press is set ON. For more information, refer to
Section 5.8.3. Setting the tank pressure pairing). If the D6i is in the TIME mode,
enter the DIVE mode by short-pressing the MODE button. The D6i should display
“cd:--” in the lower left corner of the display.
the Suunto D6i settings (Tank Press is set ON. For more information, refer to
Section 5.8.3. Setting the tank pressure pairing). If the D6i is in the TIME mode,
enter the DIVE mode by short-pressing the MODE button. The D6i should display
“cd:--” in the lower left corner of the display.
3.
Slowly open the cylinder valve fully and pressurize the system. The transmitter
starts transmitting when the pressure exceeds 15 bar/300 psi.
starts transmitting when the pressure exceeds 15 bar/300 psi.
4.
Take the Suunto D6i unit close to the transmitter. The unit will then quickly display
the selected code number and then start displaying the transmitted cylinder
pressure. The wireless transmitter indicator (blinking flash symbol) is displayed
every time the Suunto D6i receives a valid signal.
the selected code number and then start displaying the transmitted cylinder
pressure. The wireless transmitter indicator (blinking flash symbol) is displayed
every time the Suunto D6i receives a valid signal.
51