Roland KCW-1 用户手册
10
Connect your KCW-1
Switching the Power On and
Off
941
Once the connections have been completed (p. 8), turn on
power to your various devices in the order specified. By
turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
power to your various devices in the order specified. By
turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
1.
Make sure that all volume controls on the KCW-1 and
connected devices are set to 0.
2.
Turn on all the devices connected to the KCW-1’s input
jacks.
3.
Turn on the KCW-1.
4.
Switch on any equipment connected to the KCW-1’s
THRU OUT jacks.
5.
Adjust the volume levels for the devices.
6.
Before switching off the power, lower the volume on
each of the devices in your system and then TURN OFF
the devices in the reverse order to which they were
switched on.
942
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally. For protection from sudden big sound, always
make sure to have the volume level turned down before
switching on power.
943
* Always make sure to have the volume level turned down before
switching on power. Even with the volume all the way down,
you may still hear some sound when the power is switched on,
but this is normal, and does not indicate a malfunction.
945
* If you need to turn off the power completely, first turn off the
POWER switch, then unplug the power cord from the power
outlet. Refer to
Power Supply
KCW-1_e.book 10 ページ ２００６年９月８日 金曜日 午前１１時５０分