Roland BR-600 用户手册
126
Fixing the Pitch of Vocals (Pitch Correction)
Re
v0.10
v0.10
Each of the preset patches 1–5 uses a slightly different
method for correcting pitches. Normally, it will be sufficient
to select the patch that gives the results you like best;
however, if you cannot achieve favorable results using any
of these patches, you can change the Pitch Correction
settings to create a patch of your own.
method for correcting pitches. Normally, it will be sufficient
to select the patch that gives the results you like best;
however, if you cannot achieve favorable results using any
of these patches, you can change the Pitch Correction
settings to create a patch of your own.
1
Select a preset patch to base your new patch on.
2
Press CURSOR [
] [
] to move the cursor to
“EDIT,” and press [ENTER].
The Pitch Correction edit screen will appear.
3
Use [CURSOR] to move the cursor to the setting you
want to change and select a new value using the
TIME/VALUE dial.
fig.03-640
Type
LO.MALE, HI.MALE, LO.FEML, HI.FEML
Set this parameter to match the type of voice in the
original vocal part. If this parameter is not set correctly,
problems will be more likely to occur in pitch detection
and correction.
original vocal part. If this parameter is not set correctly,
problems will be more likely to occur in pitch detection
and correction.
LO.MALE (Low Male)
Select this setting for a low-pitched, male voice.
HI.MALE (High Male)
Select this setting for a high-pitched, male voice.
LO.FEML (Low Female)
Select this setting for a low-pitched, female voice.
HI.FEML (High Female)
Select this setting for a high-pitched, female voice.
*
If the BR-600 is frequently incorrect when detecting the
pitch, either change the type setting. In certain cases,
this will reduce the number of incorrect detections.
pitch, either change the type setting. In certain cases,
this will reduce the number of incorrect detections.
Smooth
0 – 100
This setting determines how quickly pitch correction
will react to changes of pitch in the original vocal part.
Large values result in a longer time before correction is
applied; consequently, changes in pitch will be more
gradual. Small values produce rapid changes in pitch.
will react to changes of pitch in the original vocal part.
Large values result in a longer time before correction is
applied; consequently, changes in pitch will be more
gradual. Small values produce rapid changes in pitch.
Corrections that are made too rapidly seem robotic.
However, if the correction is too smooth, in some cases
it may appear as if no correction has been applied. For
natural sounding pitch corrections, set the value in a
range between 20 and 40.
However, if the correction is too smooth, in some cases
it may appear as if no correction has been applied. For
natural sounding pitch corrections, set the value in a
range between 20 and 40.
4
Press [EXIT].
The Pitch Correction’s patch selection screen will
appear.
appear.
fig.35-650
5
To save your modified settings, carry out the
procedure described in “Saving the Pitch Correction
Settings (Write).”
Setting the Correction
Method for Vocal Pitch
(Pitch Correction Edit)
Method for Vocal Pitch
(Pitch Correction Edit)
BR600_e2 126 ページ ２００６年４月１７日 月曜日 午前９時３分