Rane Welder RPM 26z 用户手册

Manual-2

1

 Signal/Overload LED meters indicate the presence of significant audio signal or overload for Inputs and Outputs. These 3-color 

meters indicate the available headroom once the analog signal has been converted to digital: -4 dBFS (red, near clipping), -12 

dBFS (yellow, high normal level), and -48 dBFS (green, low level). The analog signal level depends on the input and output set-

tings and is displayed in Drag Net’s Meter window.

2

 AES3 LOCK LED lights solidly when a valid AES3 digital signal is detected on the AES3 input jack. There does not need to be 

an audio signal present at the input, only the “carrier” signal.

3

 PRESET LED displays the number of the most recently recalled Preset, numbered 0 through 24.

4

 VIP LED flashes when a change is detected on the Versatile Input Port (VIP). This port is used for direct electrical connections to 

potentiometers, switches or other logic ports. See Control Connections on page Manual-4 for details. 

5

 ETHERNET LED flashes when an Ethernet data packet for this device is received.

6

 STATUS LED reflects the overall status of the unit:

  Red      - initializing (briefly) or possible internal error.

  Yellow - working, but not currently processing audio.

  Green   - processing audio.

7

 POWER LED lights solidly when the unit is powered on.

1

 POWER IEC jack connects to AC line voltage, 100-240 VAC ±10%. Use the 3-prong IEC power cable (included).

2 

 on Euroblock connectors. 

3

 Balanced analog audio OUTPUTS 1 through 6 on Euroblock connectors. Same wiring notes as the Inputs. 

4

 AES3 digital audio INPUT  is an XLR female connector. See Digital AES3 Input on page Manual-3.

5

 VERSATILE INPUT PORT provides 8 logic or voltage inputs for remote level control and Preset recall on a Euroblock 

connector. See Control Connections on page Manual-4.

6

 LAN and LINK reflect the state of the Ethernet connection. LINK lights solidly when a valid connection to another Ethernet 

device (e.g., a PC) is detected. LAN flashes when communicating with another Ethernet device.

7

 10Base-T jack accepts a standard Ethernet cable with a RJ-45 connector. See Control Connections on page Manual-4.

8

 DEFAULT button recalls Preset 1 when pressed. Holding this button while applying power puts the unit into a codeload mode 

for updating firmware.