Real Flame Fireplace Model #7100 7100 用户手册
Step Two
figure 2
- Turn unit so you are looking at the back of it.
- Place the Left Firebox Trim (8) against the
two mounting blocks located on the back of
the Left Trim Panel. Attach trim through
three holes in trim.
- Repeat with Right Firebox Trim(9).
- From the top of unit slide Center Panel (11)
between the Left and Right Trim panels. Align
the top of the Center Panel so it is flush with
Tops of the Left and Right Trim Panels. Attach
through four holes in mounting strips on both
sides.
Step Three
figure 3
- Place the Top Firebox Trim (10) so
mounting blocks on trim overhang the
backs of the Left and Right Side Firebox
Trim. Fasten Trim through holes on each
end of the trim, then fasten through
mounting blocks on each end of the trim.
- Set Firebox Support (6) behind fireplace
opening so support is between Left and
Right Trim Panels (4) and (5). Attach with
screw through holes on left and right side
of the Firebox Support.
- Set Mantel Top (7) onto top of unit so
trim on Top overhangs front and Sides.
- First attach top through two holes in the
center panel, then proceed to attach
through the single hole on each side of the
trim panels.
7100-1 Rev. 042006
11
7
6
10
9
8
You are now ready for the firebox
installation. Please refer to the instructions
that are included with your firebox.
figure 3
figure 2