Raymarine Wind & Close Hauled Wind Instrument ST60 用户手册

14

ST60 Wind & Close Hauled Wind Instrument Owner’s Handbook

age the equipment, but may cause the loss of some information and may 
change the operating mode.

• Raymarine specified cables are used. Cutting and rejoining these cables can 

compromise EMC performance and must be avoided unless doing so is 
detailed in the installation manual.

• If a suppression ferrite is attached to a cable, this ferrite should not be 

removed. If the ferrite needs to be removed during installation it must be reas-
sembled in the same position.

The following illustration shows typical cable suppression ferrites used with 
Raymarine equipment. Always use the ferrites supplied by Raymarine.

Connections to Other Equipment
If your Raymarine equipment is to be connected to other equipment using a cable 
not supplied by Raymarine, a suppression ferrite MUST always be attached to the 
cable near the Raymarine unit.

As it is not possible to describe procedures for all possible installation scenarios, 
the procedures given here describe the broad requirements for installing wind 
transducers and ST60 Wind instruments. Adapt these procedures as appropriate, 
to suit your individual requirement.

Unpack your ST60 instrument and check that the items described in the 

Preface

 

are present:

D3548-6