Yamaha XMV8280/XMV8140/XMV8280-D/XMV8140-D 业主指南

XMV8280/XMV8140/XMV8280-D/XMV8140-D Owner’s Manual



*2: “XY” means “operate X, and then operating Y.” For example, “[SELECT] A  encoder” means that you should press the [SELECT] 

A, and then operate the encoder.

attenuator
(ATT)

[SELECT] (of the channel to 
be changed)  encoder 

*2

The [SELECT] indicator of the selected channel 
will lit, and the attenuator value can be edited by 
the encoder.
The range of adjustment is -99 dB–0 dB in 1 dB 
steps.

polarity
(POL)

[SELECT] (of the channel to 
be changed)  encoder 

*2

The [SELECT] indicator of the selected channel 
will light, and the polarity can be changed by using 
the encoder.

HPF
(HPF)

[SELECT] (of the channel to 
be changed)  encoder 

*2

The [SELECT] indicator of the selected channel 
will light, and the high pass filter (HPF) on/off set-
ting and cutoff frequency can be changed by using 
the encoder. This will be set to 80 Hz if a high 
impedance connection is specified; it will be turned 
OFF if a low impedance connection is specified.

In order to protect the amplifier, the HPF of the 
selected channel cannot be turned OFF if a high 
impedance connection is specified.

analog/digital input 
selection
(SRC)

Encoder operation

Use the encoder to change the analog/digital input 
selection. This selection applies to all channels.

Do not select “analog” if your audio network has 
been configured using the [YDIF] connectors or 
Dante [PRIMARY]/[SECONDARY] connectors.
Selecting “analog” will interrupt audio transmission 
to and from the devices that are connected via the 
YDIF connectors or Dante connectors.

[SIGNAL] indicator 
switching
(SIG)

Encoder operation

Use the encoder to specify whether the [SIGNAL] 
indicators will show the input signal level or the out-
put signal level.

digital input 
sensitivity
(DIS)

Encoder operation

Use the encoder to change the digital input sensi-
tivity setting. To prevent inadvertent setting, the 
value does not change right away when the 
encoder is turned. Until the input sensitivity 
changes, “

– – –

” appears in the display.

NOR

Normal polarity

INV

Inverted polarity

OFF

HPF is off

H40

Cutoff frequency is 40 Hz

H80

Cutoff frequency is 80 Hz

ANA

Analog input connectors

DIG

[YDIF] connectors 
(XMV8280/XMV8140)

Dante [PRIMARY]/
[SECONDARY] connectors
(XMV8280-D/XMV8140-D)

IN

Input

OUT

Output

D20

0 dB

D03

+17 dB

– – –

(value in process of being 
changed)