Utica Boilers JE 用户手册

4

Perform general housekeeping and maintenance as speci-

fied below.

• Boilers are equipped with safety valve (steam). 

Refer to manufacture's instructions for operation and 

maintenance. 

• If valve leaks steam when boiler is operating at normal 

pressure it must be replaced. Contact qualified service 

agent to replace or repair.

• On steam boilers with manual low water cut-off valves, 

open purge valve until water flows clear.  See Figure# 3.

• Contact qualified agency to perform maintenance and 

cleaning per Installation, Operation and Maintenance 

manual.  

• Inspection will include examining all flue product 

carrying areas, vent system, burner and heat 

exchanger.  

• Filling the boiler if drained as part of End of Heating 

Season procedure and blowing down the boiler.

Before the beginning of each heating season have a 

qualified agency check and clean the boiler. 

Check for the following:

Flue ways for dirt and scale.

Venting flue connectors for plugging, sagging, rust 

through and solid joints.

Burners and pilot for proper flame and operation.

Gas piping for leaks.

Operation of electronics and wiring condition.

Functionality of low water cutoff (steam).

Functionality of Pressure Control.

Water pump oiling (See manufacturer's manual).

Safety relief valve or safety valve.

Blow down.

Air vents on steam heaters.

Operation of other custom system components.

Purge air from water systems.

Clean and Flush steam systems, if required, and fill to 

proper level. (See Figure #3)

Burn and scald hazard.  Discharge of water, vapor 

and steam may scald. Failure to follow these 

instructions could result in death or serious injury.

     

Burn and scald hazard.  Discharge of water, vapor 

and steam may scald. Water and steam are under 

pressure, open all valves slowly. Failure to follow 

these instructions could result in death or serious 

injury.