Siemens WD7005 用户手册

37

Mix1 tablespoon of fabric softener
with 1/2 litre of water and pour 
into chamber I of the detergent
dispenser.

Foam coming out of the
detergent dispenser.

To much detergent.

Reduce the amount of detergent
next time.

Repeated spinning at short
intervals.

This is not a fault.
The imbalance compensation system is attempting to balance 
the load through repeated spins.

Select the desired dying
programme.

Drying programme does
not start.

Drying programme not 
selected.

Set the reasonable drying
time.

Drying time not set,
or
set drying time is too short.

Turn on the tap.

Tap not turned on.

Check whether laundry is 
trapped in door.
Close the washer-dryer
door ( click should be heard).

Washer-dryer door not 
closed properly.

Clean the pump, see page 32

Pump is blocked.

Wash large and small items 
together to reduce imbalances.

Add a more appropriate amount 
of detergent next time.

The foam detection feature
has activated an additional
rinsing cycle to reduce the
amount of foam.

The programme takes
longer than usual.

This is not a fault.
The imbalance compensat-
ion system is attempting to
balance the load by distrib-
uting the laundry more 
evenly.

Not enough detergent.

Unsatisfactory washing
result.

  

Grey residues on the
laundry.

Select  Rinsing  immediately, or
brush off spots when laundry is 
dry.

Detergent residual on the
laundry.

The degree of dirt was
higher than supposed.

Select a more suitable program.

Add detergent according to the
manufacturer's specifications.

Some phosphate-free 
detergents contain 
water-insoluble residues
that may appear as light
spots on the laundry.

Dirt accumulation from
ointments, fats or oils.

Add the maximum amount of det-
ergent and select the highest
permissible temperature next time.

Programme duration changed 
during the programme
sequence

Not a fault.
See also explanations in the chapter  programme duration  
from page 9.