Siemens WD7005 用户手册

49

Before transporting the washer-dryer:

-   Turn off the water tap,

-   Drain any residual washing solution (refer to
    Page 32),

-   Release the water pressure in the supply hose
    (refre to Page 33),

-   Disconnect the washer-dryer from the mains,

-   Dismantle the supply and drainage hose,

-   Install the transport bolts.

-   Having transported the appliance and ensured
    proper installation and connection, allow the
    Draining programme to run through before
    starting the first wash programme.

Remove the covers.

Preparing the transit bolt(see picture: page 44):
Pull the bolt out of the sleeve until the end of the
bolt is flush with the end of the sleeve.

Insert and tighten the bolts.
The lug on the washer must be located in the
groove in the rear panel of the housing.