Schlage CO-100 用户手册
8
CO-100 Offl ine Lock User Guide
RESETTING TO FACTORY DEFAULTS
!
All information in the lock will be deleted and reset to factory defaults!
In the factory default reset state, offl ine locks have a default PIN of 13579 and “#”, which can be used
for installation and testing.
for installation and testing.
Follow these steps to reset to factory defaults.
1. Remove the top inside cover.
2. Remove one battery from the battery pack to disrupt power. Wait 5 to 10 seconds for power to run
out in the lock.
3. Press and hold the Schlage button while reconnecting the battery
into the battery pack to resupply power.
4. Continue holding the Schlage button, and wait for two beeps to
sound and two green blinks of the Schlage button.
5. Release the Schlage button.
6. Press and release the Schlage button three (3) times within 10
seconds of the beeps and blinks at step 4. One beep will sound and
one red blink will occur with each press.
one red blink will occur with each press.
7. The Schlage button will light green for one second and a one-second
beep will sound, indicating that the lock has been reset.
If the Schlage button is not pressed 3 times within 10 seconds,
two beeps and two red blinks indicate timeout.
8. Replace the top inside cover.
To test, enter 13579 and “#”. The Schlage button will blink and the lock will unlock.
TIP
If the Schlage button is
not pressed and held
while reconnecting the
battery, then the lock
is ready for normal
operation (as after a
power-on reset).
not pressed and held
while reconnecting the
battery, then the lock
is ready for normal
operation (as after a
power-on reset).