RoboteQ Dual Channel High Power Digital Motor Controller AX3500 用户手册

175

The AX3500 Speed Controller can be programmed to operate in many modes using 
a simple set-up procedure. Two buttons and a 7-segment LED display allow the user 
to examine and change these settings. Alternatively, the controller may be pro-
grammed using a PC connected to the AX3500 controller through the RS232 serial 
communication port.

The new settings are then permanently stored in the controller’s Flash memory so 
that jumpers are not required, resulting in improved system reliability.

There are three methods for programming the AX3500’s settings:

Using the controller’s built-in switches and display. This method is described 
in details in this chapter.

Using the PC-based Configuration Utility. See “Using the Roborun Configura-
tion Utility” on page 181.

Sending RS232 commands manually. See “Automatic Switching from RS232 
to RC Mode” on page 169.

Two switches and an LED display are provided to let you easily configure the con-
troller in any of its many operating modes. Unlike the RS232 programming mode, 
the switches will let you configure the controller without the need for external hard-
ware or special connectors. In this mode, the controller may be configured while 
installed on the robot without the need for special tools or a PC. Figure 98 shows 
the placement of the switches and display.