RoboteQ Dual Channel Digital Motor Controller AX500 用户手册

151

board against a vertical surface as shown in the figure below will ensure a better natural 
convection flow and is, therefore, recommended.

For high current applications, it is possible that the controller may heat up faster and to a 
higher temperature than can be dissipated by the using natural convection alone.

In these applications, you should ensure that air flow exists to remove the heat from the 
heat sink. In the most extreme use, you should consider using an external fan to circulate 
air around the controller.

The AX500 can be attached to a metal chassis to improve heat dissipation. For this purpose 
the board has holes at the corners of the PCB, which can be used to fasten it to the chas-
sis.

Of course first it is necessary to remove the blue heat sink, which is mounted as standard.

A total of 6 screws for the AX500 are required, four on the corners and two in the heat sink 
area.

In order to avoid that components leads sticking out the back of the PCB make contact 
with the chassis it is needed to interpose a metal bar (interposer) of thickness sufficient to 
distance the PCB from the surface of the chassis.

FIGURE 88. Mount the controller against a vertical surface to maximize convection flow