Robic SC-594 用户手册

 

 
 

 

 
 - After all adjustments are completed, press button S2 to exit the setting mode. 
Remark: 
1. When the seconds digits count between 30 to 59 and the button S1 is pressed while in setting mode, the 
    seconds are reset to 00 and one minute is added. 
2. If 24 Hr display format is selected, there is no AM flag “A” or PM flag “P”. 
3. If there is no button operation for 2-3 minutes in setting mode, the watch will return back to Normal Time mode 
    automatically. 
4. Press button S2 to enter or exit Pulse Rate Monitor mode. 
 
 
(F) HOW TO USE CHRONOGRAPH 
 

 

3

 
 
 
 
 
 
 
 
 
- Press button S3 to show Chronograph mode, “CH” displayed in the bracket. 
- Press button S1 to start the chronograph, “RUN” will be displayed. 
- Press button S4 to take split times (“SPL” displayed), the display will freeze at total accumulated time for about 
  10 seconds, then the display will return to the current running time automatically. Press button S3 for fast 
  escape. 
- Press button S1 to stop the chronograph. Then press button S1 to start the chronograph again or press button 
  S4 to reset the chronograph to 00’00”00. 
Remark: 
1. The chronograph is with 1/100-second resolution up to 100 hours. 
2. Press button S2 to enter or exit Pulse Rate Monitor mode. 
  
                                                                                                                                                                                                      
(G) HOW TO USE THE COUNT DOWN TIMERS 

 
 
 
 
 
 
 
 
 
 
- Press button S3 to show Timer mode, “CS”, “Cr” or “CU” displayed in the bracket. 
- Press button S4 to select Count Down Stop “CS”, Count Down Repeat “Cr” or Count Down /Up “CU” function. 
- Press & hold button S2 for 3-4 seconds to enter setting mode. The minute digit start flashing. 
- With each press of button S1, the selected digits to be adjusted (flashing) can be made. Press & hold button S1 
  for fast setting. 
- Press button S3 to select minute or hour digit for setting. 
- After all adjustments are completed, press button S2 to exit the setting mode. 
- Press button S1 to start the timer. 
Remark: 
1. The count down timer is with 1-second resolution and with working range from 1 minute to 19 hours 59 

minutes. 

2. The watch will give out 5 “BEEP” at 5 minutes, 3 “BEEP” at 3 minutes and 1 “BEEP” at 1 minute, 5 sec., 
    4 sec., 3 sec., 2 sec. and 1 sec. before the timer count down to zero. And the watch will beep for 1-2 seconds 
    when the timer count down to zero. 
3. If there is no button operation for 2-3 minutes in setting mode, the watch will return back to Timer mode 
    automatically.