Recoton/Advent U31-LP2 用户手册

FPI U31-2 Gas Fireplace Insert

1)  Lay the faceplate panels fl at, face down on 

something soft so they don't scratch.

2)  Take the top faceplate and align the holes in 

it with the holes in the side panels.  Using the 
screws provided, attach from the top of the 
panel (the holes in the top panel are slightly 
larger than the holes in the side panel to 
facilitate easier installation). Diagram 1.

 

Hint: Don't tighten the screws down com-

pletely at this point, continue on with steps 
3 and 4 and do a trial fi t to the unit.  Make 
any necessary adjustments and when it fi ts 
properly then tighten down the screws.

 

Hearth Trim Option: Hearth Trim is an 
option that can be used to fi nish off the 
installation when the bottom of the fi replace 
is higher than the hearth or to raise the fi re-
place. Attach the Hearth Trim to the bottom 
of the faceplate side panels with the screws 
provided.  See Diagram 1.

3)  Using the connectors provided, join the left 

side trim (with the ON/OFF switch) to the 
top trim. Diagram 2. Connect the right side 
trim to the top trim.

4)  Place the trim on the assembled faceplate 

panels, aligning the wire connections from 
the switches with the notch on the left side 
panel.

5)  Connect the fan switch wires by taking the 

black and red wires with the male ends (in 

the grey harness) and connect them with 
the wire connectors from the fan speed 
control.

6)  Connect the ON/OFF switch wires by taking 

the black and red wires with the female ends 
and connect them to the ON/OFF switch.

 
7)  Tuck the wires into the faceplate to keep 

them away from the insert using the clip 
provided. Attach the clip to the rear of the 
faceplate to ensure that the wires do not 
touch the side of the unit. Diagram 3.

8)  The power cord should be run behind the 

faceplate panel.

9)  Attach the brass trim to the faceplate by 

drilling a 1/8" hole through into the faceplate 
using the hole in the trim as a guide. Fasten 
the trim to the faceplate panels using the 
plated screws. Diagram 4.

10) Attach the faceplate panels to the insert 

body using the 4 remaining black screws. 
Diagram 5.

11) Push the Regency logo plate into the two 

holes in the bottom left corner of the face-
plate.

1)     Install Logs before going on to the next 

step. See the Log Installation instruction 
sheet or page 9.

2)  Install the bottom glass trim by hooking the 

trim into the lip on the fi rebox base. The trim 
will not fi t into place if the glass is installed 
fi rst.