Recoton/Advent U31-LP2 用户手册

FPI U31-2 Gas Fireplace Insert

1)  Lay the faceplate panels fl at, face down on something soft so they 

don't scratch.

2)  Attach the side fi ller brackets to the left and right sides using 3 screws 

and washer per side.

3)  Attach the right and left cast sides to the top using 2 screws per 

side. 

5)  Connect the ON/OFF switch wires 

by taking the black and red wires 
with the blue female ends thru 
the hole provided and connecting 
them to the ON/OFF switch.

6)  Connect the fan switch wires by 

taking the black and red wires 
with the  male ends (in the grey 
harness) thru the hole provided 
and connect them with the wire 
connectors from the fan speed 
control.

7)  Insert wires into the strain relief 

and install into switch box as-
sembly. 

8)  Place the switch box assembly 

over the boss on the rear left 
side piece and secure with one 
screw.  

4)  Use a measuring tape to ensure that the distance between the left 

and right side pieces is 28" (711mm).

9)  Tuck the wires into the faceplate to keep them away from the insert 

using the clip provided.  Attach the clip to the rear of the faceplate 
to ensure that the wires do not touch the side of the unit. 

NOTE: Do not install Cast Faceplate when unit is installed 
into a Zero Clearance Unit.

10) The power cord should be run behind the 

faceplate panel.