Rangemaster 110 DUAL FUEL U109600-02 用户手册
22
Moving your cooker
Switch off the electricity supply.
The cooker is heavy; two people may be required
to move it.
to move it.
First remove the drawer. Pull it right out and lift
up the ends of the plastic clips (one each side)
to release the catches holding the drawer to the
side runners and at the same time pull the drawer
forward and away from the side runners.
up the ends of the plastic clips (one each side)
to release the catches holding the drawer to the
side runners and at the same time pull the drawer
forward and away from the side runners.
For safety’s sake push the drawer runners back out
of the way.
of the way.
There are also two screw down levelling feet at
the front of the cooker. The cooker is also fitted
with one roller at the front and two at the back. In
normal use the front roller, designed for moving
the cooker, is raised so that the front feet support
the cooker. The levelling tool that controls this
roller should be in the storage drawer. If you
cannot find the levelling tool, contact your installer
(see the start of the ‘Installation’ section of these
instructions).
the front of the cooker. The cooker is also fitted
with one roller at the front and two at the back. In
normal use the front roller, designed for moving
the cooker, is raised so that the front feet support
the cooker. The levelling tool that controls this
roller should be in the storage drawer. If you
cannot find the levelling tool, contact your installer
(see the start of the ‘Installation’ section of these
instructions).
Locate levelling tool as shown.
Turn the levelling tool clockwise, two full (180°)
turns. It will be stiff. The front of the oven will rise
slightly as the roller drops down.
turns. It will be stiff. The front of the oven will rise
slightly as the roller drops down.
Open the grill door and right hand oven door so
that you can get a good grip on the bottom of the
control panel as you move the oven.
that you can get a good grip on the bottom of the
control panel as you move the oven.
Do not move the oven by pulling the hand rail,
door handles or knobs.
door handles or knobs.
Move the oven a bit at a time, checking behind it
to make sure the gas hose is not caught. Make sure
both electricity and gas cables have sufficient slack
to move the cooker forward as you go along.
to make sure the gas hose is not caught. Make sure
both electricity and gas cables have sufficient slack
to move the cooker forward as you go along.
If a stability chain is fitted, release it as you ease
the cooker out.
the cooker out.
When you replace the cooker, wind it down off
the front roller by turning the levelling tool anti-
clockwise. This is important. It will stop the cooker
moving accidentally, while in use.
the front roller by turning the levelling tool anti-
clockwise. This is important. It will stop the cooker
moving accidentally, while in use.
To refit the draw
To replace the drawer in the cooker, pull the side
rails fully out. Carefully move the drawer back
between the rails and rest it on the side rails.
rails fully out. Carefully move the drawer back
between the rails and rest it on the side rails.
At each side hold the front of the drawer and pull
the side rail forward so that the clips click into
position holding the drawer to the side rails.
the side rail forward so that the clips click into
position holding the drawer to the side rails.