Psion Teklogix Schnellstart- Anleitung 7525 用户手册
Psion Teklogix WORKABOUT PRO With Windows Mobile 2003 SE User Manual
267
Chapter 8: Expansion Modules
Installing A GSM/GPRS Module
•
Fit the antenna at the top of the unit making certain that the antenna contacts
are aligned with the contacts on the GSM/GPRS module (see Figure 8.7).
Ensure that the tab at the top of the antenna is inserted under the lip of the
WORKABOUT PRO’s black plastic frame (Figure 8.8).
are aligned with the contacts on the GSM/GPRS module (see Figure 8.7).
Ensure that the tab at the top of the antenna is inserted under the lip of the
WORKABOUT PRO’s black plastic frame (Figure 8.8).
•
Use the screws provided to secure the antenna on the metal frame. Tighten
the screws to a torque of 2 lbs-in (2 kgf-cm, or until finger tight.
the screws to a torque of 2 lbs-in (2 kgf-cm, or until finger tight.
Figure 8.7 Installing The Antenna
Figure 8.8 An Installed GSM/GPRS
•
Slide the SW1401 switch to the right to turn power back on.
•
Replace the end-cap.
Tighten the end-cap screws to a torque of 3 lbs-in (3kgf-
cm), and replace the
back plate and battery.
•
Verify the installation by turning on the unit and checking that the signal
strength icon is available in the taskbar, or that “Expansion Slot - Psion Tek-
logix GPRS” is listed under
strength icon is available in the taskbar, or that “Expansion Slot - Psion Tek-
logix GPRS” is listed under
Properties
, in the
Control Panel System Properties
menu.
Tab
Antenna
Antenna Contacts
GSM/GPRS Module
Antenna
Location of Antenna Tab
tucked beneath unit frame
GSM/GPRS Module with
SIM Card Stopper Plate
SIM Card Stopper Plate
in place
Scanner Flex Cable