Proxim AP-4000 用户手册
Advanced Configuration
AP-4000 Series User Guide
Management
76
Figure 4-21 Automatic Configuration Screen
Set up Automatic Configuration for Dynamic IP
Perform the following procedure to enable and set up Automatic Configuration when you have a dynamic IP address for
the TFTP server via DHCP.
the TFTP server via DHCP.
The Configuration filename and the TFTP server IP address are contained in the DHCP response when the AP gets its IP
address dynamically from the DHCP server. A Syslog server address is also contained in the DHCP response, allowing
the AP to send Auto Configuration success and failure messages to a Syslog server.
address dynamically from the DHCP server. A Syslog server address is also contained in the DHCP response, allowing
the AP to send Auto Configuration success and failure messages to a Syslog server.
NOTE: The configuration filename and TFTP server IP address are configured only when the AP is configured for Static
IP. If the AP is configured for Dynamic IP these parameters are not used and obtained from DHCP.
1. Click Configure > Management > AutoConfig.
2. Check Enable Auto Configuration.
When the AP is Configured with Dynamic IP, the DHCP server should be configured with the TFTP Server IP address
("Boot Server Host Name", option 66) and Configuration file ("Bootfile name", option 67) as follows (note that this
example uses a Windows 2000 server):
("Boot Server Host Name", option 66) and Configuration file ("Bootfile name", option 67) as follows (note that this
example uses a Windows 2000 server):
3. Select DHCP Server > DHCP Option > Scope.
The DHCP Options: Scope Screen appears.