PGS DIRECT VENT FIREPLACE TC36 AR 用户手册
18 36ARB2
050505-36
VENT PIPE SEALANT
APPROVED
"HIGH TEMP."
SELF-ADHESIVE
ALUMINUM
TAPE
Fig. #23
VENT PIPE SEALANT
All outer joints of the vent pipe must be sealed with the ap-
proved "High Temp." self-adhesive aluminum tape provided.
Wrap the tape completely around the joint and press fi rmly
in place.
proved "High Temp." self-adhesive aluminum tape provided.
Wrap the tape completely around the joint and press fi rmly
in place.
VENT PIPE
INSULATION
Fig. #24
COVER (2 pcs.)
INSULATED COLLAR SHIELD
(Included Pt# TC36.9709)
After sealing the vent pipe an insulating blanket and cover
must be installed around the vent pipe, fl ush with the top of
the unit and secured by fi tting tabs through slots and bending
over tabs 180° as shown in fi g #24. The parts required are
included. *NOTE: bending tabs to 90° away from arc bend
must be installed around the vent pipe, fl ush with the top of
the unit and secured by fi tting tabs through slots and bending
over tabs 180° as shown in fi g #24. The parts required are
included. *NOTE: bending tabs to 90° away from arc bend
BEND
TABS
TABS
INSULATED COLLAR
SHIELD
SHIELD
(Included)
MUST
BE USED. SEE SECTION
BELOW
BELOW