Patton electronic 07M6070-UM 用户手册
Introduction
14
NanoServ™ User Manual
3 • Peripherals
Introduction
This chapter shows how to connect various devices to the NanoServ™ System. Connect all the devices you
will be using before turning on the power. The power adaptor should be connected last.
will be using before turning on the power. The power adaptor should be connected last.
Connecting the monitor
*Note: Monitor not included.*
Connecting the USB
The system provides two USB ports (one in the front and one at the back of the case).
The Interconnecting cables shall be acceptable for external use and shall be
rated for the proper application with respect to voltage, current, anticipated
temperature, flammability, and mechanical serviceability
rated for the proper application with respect to voltage, current, anticipated
temperature, flammability, and mechanical serviceability
Table 2. Connecting the monitor
VGA Connection
Depending on your preference, select a con-
ventional CRT or LCD VGA monitor.
ventional CRT or LCD VGA monitor.
Connect the VGA cable of your monitor to the
15-pin D-Sub VGA port on the back of the sys-
tem.See the diagram on the left.
15-pin D-Sub VGA port on the back of the sys-
tem.See the diagram on the left.
Table 3. Connecting the USB
Connecting the USB
A USB port is available on the front cabinet of
the unit. Another port is available on the back
of the unit.
the unit. Another port is available on the back
of the unit.