Patton electronic 07M6070-UM 用户手册

This section describes the techniques of resolving some basic problems that you may encounter when using 
your NanoServ™. For more troubleshooting guidelines, see “Contacting Patton for assistance” on page 27.

•

Make sure that the NanoServ™ is properly secured and plugged into a power source before it is turned on. 
Make sure the power indicator shows the power is on. See Chapter 2,

page 10 for more information about the system power buttons and other connections.

•

 When the NanoServ™ is plugged into a power strip or the UPS (Uninterruptible Power Supply), make 
sure the power strip or UPS is turned on and working normally.

•

 Check if your VGA or LCD monitor is properly plugged into a power source and turned on. Make sure the 
brightness and contrast controls are adjusted correctly. See the manual that came with your monitor for 
details.

•

 If your power control button does not function, remove the AC adaptor. Wait for one minute, and then 
reattach the power connection before pressing the power button.

•

 Condensation may cause the NanoServ™ to malfunction for awhile. If this happens, do not use the 
NanoServ™ for at least one hour after the condensation has disappeared.

•

 When you have checked all the above guidelines and the NanoServ™ still does not work, remove the 
power adaptor from the NanoServ™, unplug the power cord, and plug it in again. Then, turn on the 
power. This double check is important because sometimes a cable is loose or not completely plugged in.

-

If the BIOS error message appears, press any key to resume or press <DEL> to enter the BIOS setup main 
menu. 
Follow these steps:

1. Press <DEL>, and the BIOS Setup main menu will appear. Check if HDD is detected at “Pri Master”. If 

it is not detected, use the “Sel” keys <   > to choose “AUTO”, then go back to the main menu by pressing 
<ESC>. Move your cursor down with the “Sel” keys <   > , and choose “Save Settings and Exit”, a message 
dialog appears as seen below, press <Enter>. 

2. “Save current settings and exit (Y/N)?  Y ”

3. Go to “Auto Configuration with Optimal Settings” using the “Sel” keys <   >, then press <Enter>.  A mes-

sage dialog appears as seen below, press “ Y ”, then press <Enter> to save and recover the factory setting.

4.  “Load high default settings (Y/N)?  N  ”