Texas Instruments TRF1500 用户手册
SWRA004A
TRF1500 Integrated Dual-Band RF Receiver User’s Guide
61
The LNA input return loss is measured at the input Port J10. Using
the calibration performed above, set the network analyzer to
measure S11.
the calibration performed above, set the network analyzer to
measure S11.
Low-Band LNA: Output Return Loss
Control state: 011000
The LNA output return loss is measured at the output port J15.
Using the calibration performed above, set the network analyzer to
measure S22.
Using the calibration performed above, set the network analyzer to
measure S22.
Low-Band LNA: Isolation
Control state: 011000
The isolation of the Low Band LNA is a measure of the attenuation
between the output of the LNA and the input of the LNA. . Use the
calibration performed above; set the network analyzer to measure
S12.
between the output of the LNA and the input of the LNA. . Use the
calibration performed above; set the network analyzer to measure
S12.
Low-Band LNA: 1dB Input Compression Point
Control state: 011000
SEE APPENDIX A: TEST BENCH SETUPS
Test setup Figure 27
The 1 dB input compression point is the RF input power at which
the gain compresses 1 dB and when an increase in P
the gain compresses 1 dB and when an increase in P
in
causes no
further increase in the output power (P
out
). The measurement is
performed using two RF sources and a spectrum analyzer.
1) Set the RF source frequency (see Table 7) and the input
power (P
in
) to -35 dBm. Connect the RF source to the EVM RF
input port, J10.
2) Set the spectrum analyzer to measure the output power at the
desired LNA frequency.
3) Connect The EVM LNA output port, J15, to the spectrum
analyzer.
4) Measure the output power (P
out
) at the LNA frequency
5) Calculate Gain as:
Gain = P
out
- P
in