TANDBERG Codec C90 D14129.02 用户手册
D14129.02—NOVEMBER 2008
13
Codec C90
Administrator Guide
Contents
Introduction
Getting started
About the menus
About the settings
Settings Library
Cameras
Appendices
Contact us
Getting started
The video outputs at Codec C90
About main and dual monitors
The main monitor
The main monitor can be connected to the default video output HDMI
1 or one of the other outputs which are HDMI 3, DVI-I 2 or DVI-I 4.
1 or one of the other outputs which are HDMI 3, DVI-I 2 or DVI-I 4.
Connecting to HDMI 1
When you connect the main monitor to the default video output on
Codec C90 the menu, icons and other information on screen (OSD -
on screen display) will show on this monitor.
Codec C90 the menu, icons and other information on screen (OSD -
on screen display) will show on this monitor.
Connecting to DVI-I 2, DVI-I 4, HDMI 3
When connecting the main monitor to another video output, and no
menu shows on screen, you must run a shortcut on the remote control
to reset the resolution and move the OSD to this output.
The resolution will be set to the default value, which is
1280x720@60Hz for HDMI and 1024x768@60Hz for DVI.
The menu on screen, icons and other information (OSD - on screen
display) will be moved to the selected output.
menu shows on screen, you must run a shortcut on the remote control
to reset the resolution and move the OSD to this output.
The resolution will be set to the default value, which is
1280x720@60Hz for HDMI and 1024x768@60Hz for DVI.
The menu on screen, icons and other information (OSD - on screen
display) will be moved to the selected output.
Key sequence
If connected to DVI-I 2, DVI-I 4 or HDMI 3 you must run the following
shortcut or key sequence on the remote control.
If connected to DVI-I 2, DVI-I 4 or HDMI 3 you must run the following
shortcut or key sequence on the remote control.
Disconnect * # * # 0
•
x
#
(where
x
is output
2
,
3
or
4
)
Example: Set DVI-I 2 as the OSD output:
Disconnect * # * # 0 2 #
•
You can also set the resolution and the OSD output by setting up a
serial port connection and run API commands. See the Codec C90
System Integrator Guide for information about API commands.
serial port connection and run API commands. See the Codec C90
System Integrator Guide for information about API commands.
Dual monitors
When you want to run a dual monitor setup, connect the second
monitor to video output HDMI 3 on Codec C90.
monitor to video output HDMI 3 on Codec C90.
Dual monitor configuration
Go to Administrator settings to set the monitor to dual:
Navigate to Settings > Administrator Settings > Video > Output >
1.
Monitor
Set the
Set the
2.
Monitor
to
Dual
.
Press
3.
Home (
) to exit.
HDMI 1
(the default connector
for the main monitor)
(the default connector
for the main monitor)
DVI-I 2
HDMI 3
(the default connector
for the dual monitor)
(the default connector
for the dual monitor)
DVI-I 4