TANDBERG CODIAN 2200 用户手册

 

18 

Depending on the configuration of the IP VCR, you may be able to make recordings non-interactively. That is, once 
connected to the IP VCR, recording takes place automatically, and with no feedback to the user. If you would prefer to 
have more feedback when making recordings, consider using the recording console (see 

). 

Otherwise, refer to the sections below for further information on making non-interactive recordings: 

• 

 

• 

 

• 

Non-interactive recording gives no feedback as to the status of recording. The IP VCR will not send video to your 
endpoint, typically causing your endpoint to display a blank screen. You will not be able to monitor how the recording 
will look. 

When the call to or from the IP VCR is connected, recording will typically start immediately. However, the IP VCR may 
have been configured to delay recording until coherent video is seen. Your system administrator may have configured the 
IP VCR in this way to ensure the best quality of recordings. 

If you are unsure of whether the IP VCR will start recording immediately or not, wait a few seconds before starting to 
speak; this will ensure the best quality recording in all circumstances. 

To make a non-interactive recording by calling the IP VCR using your video endpoint, follow these steps: 

1.  Confirm with your system administrator that the Default incoming call action of the IP VCR is to answer incoming 

calls by recording them immediately (non-interactively) (see 

). 

Alternatively, determine whether the IP VCR has any Recording IDs configured and registered with a gatekeeper, 
allowing you to make a recording by dialing a phone number (see 

). 

2.  Connect to the IP VCR using the method chosen in the previous step.  
3.  Recording will start when the call is answered. 

You may use the IP VCR web interface to call out to your video endpoint and record the session non-interactively. To 
make a recording in this way, follow these steps: 

1.  Log in to the IP VCR web interface as an administrator or user (see 

2.  Use your browser to navigate to 

. 

3.  Press 

. The recording parameters page will be displayed (see 

). 

4.  Name your recording, and identify the endpoint you wish to call out to. 
5.  Ensure 

 is not selected.