OWI AMP-04TRP 用户手册

Page 8 of 10

 

1.  No output:  Disconnect any secondary speakers and check for operation of the primary speaker only. If still 

there is no output, check for loose screws on the green input connector. It is easy to think the wires are secure 
in the connector and one wire is not. Tug on each wire to make sure each is tight.  

2.  Intermittent output: Check for shorted output causing the amplifier to into and output protection. Check each 

input wire for loose screws.  

3.  Distortion: Do not power more than one AMP04TRP on one power supply. While it will work, it will cause 

distortion. 

4.  No output, check to see that the power on light is on. It is located on the main PCB. If it is off, the power 

supply is either bad or has come loose in the power socket. 

5.  Hum, for single ended inputs, there is a need for a jumper between – and the ground screw. Most of the time, 

the jumper is needed.  

 
1.  The AMP04TRP product has been thoroughly tested and inspected at the factory. It is warranted for one (1) 

year from date of purchase.  
IT IS THE OWNERS’ RESPONSIBILITY TO ESTABLISH THE DATE OF PURCHASE BY 
ACCEPTABLE EVIDENCE AT TIME SERVICE IS SOUGHT. 

2.  Any unit, which in the judgment of OWI INC. is defective or develops defects under normal use will be 

replaced or repaired without cost within the warranty period. 

3.  This warranty will be considered void if unit has been dropped, misused, abused, altered in any manner, 

overdriven with excessive amplification exceeding manufacturer’s specification, improperly serviced or 
accidental damage. 

4.  OWI Inc. shall have no liability whatsoever for consequential damage. The sole responsibility and discretion 

of OWI Inc. under this warranty shall be limited to the repair of the product or replacement thereof. 

5.  IMPORTANT: This warranty is void unless the attached card is completed and mailed to OWI Inc. within 10 

days following the date of purchase. Units must be sent to OWI Inc. or to the dealer where purchased.