Oracle Audio Technologies E10898-02 用户手册

Configuration File Example 2

Oracle VM Server User’s Guide

#  to create "pseudo cdrom device" on /dev/loop*:

#

#    mount ca-fileserver2:/vol/export /srv/

#    mount -o loop,ro /srv/osinstall/RedHat/FC6/F-6-x86_64-DVD.iso /mnt

#

# You can tell what loop device to use by looking at /etc/mtab after the mount

# The first set of disk parameters commented out below are

#   "install time disk parameters" with the "pseudo" cdrom.

# Your new domU HVM install will see "/dev/sda" just like a usual hardware

# machine.

#disk = [  'phy:/dev/vgxen/lvol0,hda,w', 'phy:/dev/loop0,hdc:cdrom,r' ]

# Example of after-setup "HVM up and running" disk parameters below; 

#  the last three devices were added later 

#  and last two are shared, writeable.

# Note, for HVM you must use "whole" device. 

# Do not try to get domU to see a partition on a device...

#   For example, in a HVM this will not work :  'phy:/dev/vgxen/tls4-swap,hdb1,w'

# Best that you fdisk any extra or added devices within one of your domUs

disk = [ 'phy:/dev/vgxen/lvol0,hda,w',

         'phy:/dev/vgxen/tls4-swap,hdb,w',

         'phy:/dev/vgxen/sharedvol1,hdc,w!',

         'phy:/dev/vgxen/sharedvol2,hdd,w!' ]

# Result of this config file from within the new domU:

#  [root@ca-DomU ~]# sfdisk -s

#  /dev/sda:  10485760

#  /dev/sdb:   8388608

#  /dev/sdc: 104857600

#  /dev/sdd: 104857600

# For vnc setup try:

vfb = [ "type=vnc,vncunused=1,vnclisten=0.0.0.0" ]

# Example with a passwd of "foo".

#vfb = [ "type=vnc,vncunused=1,vnclisten=0.0.0.0,vncpasswd=foo" ]

# Remember, this file is "per individual" domU

# during install you will need to change 

# /etc/xen/xend-config.sxp

# (vnc-listen '127.0.0.1')

# to: (vnc-listen '0.0.0.0')

# 

# then from any machine do:

#  "vncviewer <your dom0 ip or hostname>"

# to see vnc console