ONKYO PR-SC5530 业主指南

Operating Other Components with the Remote Controller

60

3. 

With the number buttons, enter the 5-digit remote control 
code within 30 seconds.

 The registration is complete when the REMOTE 

MODE button flashes twice. The REMOTE MODE 
button flashes once slowly when registering the 
remote control code fails. Try the registration again.



„ Remapping the Colored Buttons

The colored button assignment on the AV controller's 
remote controller can be remapped to match that on the 
remote controller of the component whose remote control 
code you programmed to REMOTE MODE. However, you 
 >>  ># &*‚
? @

1. 

Hold down the REMOTE MODE button to map and A 
(Red) simultaneously until the REMOTE MODE button 
lights (about 3 seconds).

 Remapping is possible only for codes included in the 

categories of the Remote Control Code List (such as 
DVD player and TV).

2. 

Within 30 seconds, press the colored buttons from left to 
right, in the order you want to remap.

 For example, if the colored buttons on the remote 

controller of the other component are yellow, green, 
blue, and red from left to right, press the buttons on 
the AV controller's remote controller in that order.

 The registration is complete when the REMOTE 

MODE button flashes twice. The REMOTE MODE 
button flashes once slowly when registering the 
remote control code fails. Try the registration again.

 Pressing any other button than a colored button 

cancels the remap operation.



„ Resetting the REMOTE MODE Buttons

You can reset the remote control code registered in the 
REMOTE MODE button to its default status. This operation 
can be executed on a single REMOTE MODE button.

1. 

Press HOME for 3 or more seconds while holding down 
the REMOTE MODE button you want to reset.

 The REMOTE MODE button stays lit.

2. 

Within 30 seconds, press the REMOTE MODE button 
again.

 Resetting is complete when the REMOTE MODE 

button flashes twice.

To reset all the remote controller settings: While holding 
down RECEIVER, press and hold down HOME until 
the RECEIVER button lights (about 3 seconds). Press 
RECEIVER again within 30 seconds. Reset is complete 
when the RECEIVER button flashes twice.

Press the REMOTE MODE button programmed with 
the remote control code for the relevant AV component 
to switch the remote controller mode to that for the AV 
component. Then, operate by using the corresponding 
buttons. Available buttons vary depending on the product 
category of the component. Operation may be incorrect or 
impossible depending on the product.

3

4

1

2

1

 REMOTE MODE

2

 

, INPUT, VOL  /

3

 MUTING

4

 CH +/-

8

9

5

7

6

5

 GUIDE

6

  / / / , ENTER

7

 SETUP

8

 PREV CH

9

 RETURN