Omron SYSMAC C200HW-ZW3AT2-E-V2 用户手册
!
5-5
Section
R: Routing Table
98
5-5-11 Deleting Routing Tables from a Node — D: Delete
“D: Delete” is used to delete the routing tables set at the specified node.
Caution
Once routing tables are removed from a PC, all CPU Bus Units at the node (ex-
cept SYSMAC BUS/2 Master Units) will be reset. Before deleting the routing
tables, always make sure that the equipment will not be affected.
cept SYSMAC BUS/2 Master Units) will be reset. Before deleting the routing
tables, always make sure that the equipment will not be affected.
1, 2, 3...
1. Select “D: Delete” from the Routing Table Menu. The following window will
be displayed to prompt you to specify the node from which routing tables are
to be deleted.
to be deleted.
2. Specify the target node. Use the Cursor Keys to move the cursor to a desired
field, then enter a numeric value with Numeric Keys. (Use Alphanumeric
Keys to enter a PC ID.)
Keys to enter a PC ID.)
Press the Enter Key to register the entered value and move the cursor to the
next field.
next field.
Item
Meaning
PC ID
Enter the PC ID of the node.
Use this field only when a PC ID is to be used. If a PC ID is
used, the network address and node address will be
automatically input (see page 124).
used, the network address and node address will be
automatically input (see page 124).
Network address
Enter the network address of the node.
The setting range is between 0 and 127.
Network address 0 represents the local network (the
address of the network containing the node to which the
Controller Link Support Software is connected). (see note)
address of the network containing the node to which the
Controller Link Support Software is connected). (see note)
For CS1-series, CVM1, and CV-series PCs with multiple
Communications Units, specify the network address
explicitly.
Communications Units, specify the network address
explicitly.
Node address
Enter the node address of the node.
The setting range is between 0 and 126.
Node address 0 represents the local node (the address of
the node to which the Controller Link Support Software is
connected).
the node to which the Controller Link Support Software is
connected).
Note For CVM1 or CV-series CPU Units manufactured before April 1996
(lot No.:
jj
46), always set routing tables. Specify in “Network ad-
dress” the value (other than 0) specified in the routing tables. Refer to
the Controller Link Units Operation Manual (W309) for details.
the Controller Link Units Operation Manual (W309) for details.
Press the F10 (End) Key to cancel the routing table delete processing.
3. Press the F6 (Execute) Key. A confirmation window for deletion will be dis-
played.
4. To delete the routing tables, press “Y” and then the Enter Key. The routing
tables will be deleted.
To cancel the delete processing, press “N” and then the Enter Key.