Omron SYSMAC C200HW-ZW3AT2-E-V2 用户手册

Press the Enter Key to register the entered value and move the cursor to the
next field.

PC ID
(PC ID)

Enter the PC ID of the node.

Use this field only when a PC ID is to be used. If a PC ID is
used, the network address and node address will be
automatically input (see page 124).

Network address
(Netwk adrs)

Enter the network address of the node.

The setting range is between 0 and 127.

Network address 0 represents the local network (the
address of the network containing the node to which the
Controller Link Support Software is connected). (see note)

For CS1-series and CV-series PCs with multiple
Communications Units, specify the network address
explicitly.

Node address
(Node adr)

Enter the node address of the node.

The setting range is between 0 and 32.

Node address 0 represents the local node (the address of
the node to which the Controller Link Support Software is
connected).

Note For CV-series CPU Units manufactured before April 1996 (lot No.:

jj

46), always set routing tables. Specify in “Network address” the

value (other than 0) specified in the routing tables. Refer to the Con-
troller Link Units Operation Manual (W309) for details.

Press the F10 (End) Key to close the error log window.

3. Press the F6 (Execute) Key. The error log will be read from the specified

node and displayed on the Error Log Screen.

4. To clear the error log, press the F7 (Clear) Key. A confirmation message will

be displayed at the bottom of the screen to ask you to determine whether the
error log is to be cleared.

To clear the error log, press “Y” and then the Enter Key. Both the error log at
the node and the error log displayed on the screen will be cleared.

To cancel the processing, press “N” and then the Enter Key.

The screen can be switched by pressing the F4 (Pre Pg), F5 (Nxt Pg), Page
Up, or Page Down Key.

5. To close the screen, press the F10 (End) Key.