Omron SYSMAC C200HW-ZW3AT2-E-V2 用户手册
5-12
Section
K: Connection Information
119
however, will not be highlighted in different colors. This situation is caused by
repeated disconnection and reconnection in token ring mode resulting in dis-
crepancies in the connection information collected from the nodes.
repeated disconnection and reconnection in token ring mode resulting in dis-
crepancies in the connection information collected from the nodes.
Screen Display for Disconnected Nodes
Above the tables in the Network Configuration Screens, the status of disconnec-
tions at that time, and the disconnection log (information on detected node dis-
connections) recorded in the base node are displayed in the following way.
Above the tables in the Network Configuration Screens, the status of disconnec-
tions at that time, and the disconnection log (information on detected node dis-
connections) recorded in the base node are displayed in the following way.
Network disconnection status
Normal ring: Communications normal
Disconnecting: Disconnection
Normal ring: Communications normal
Disconnecting: Disconnection
Information on dis-
connected node 2
connected node 2
Information on dis-
connected node 1
connected node 1
Node address and con-
nector where discon-
nection occurred
nector where discon-
nection occurred
Normal Ring (Logged: Node10:SL1 Node12:SL2)
Information on disconnected nodes is not cleared when connection is
restored. For this reason, there may be times when a log is displayed even
though the network disconnection status indicates normal communications.
restored. For this reason, there may be times when a log is displayed even
though the network disconnection status indicates normal communications.
Note If there is a disconnection in one place only, the connection informa-
tion may not be concurrent, but there will be no adverse effect on data
communications. In this case, identify the location of the disconnec-
tion using the disconnection log, and remove the cause of the discon-
nection. For details, refer to information on notification and counter-
measures for network disconnections in the Optical Ring Controller
Link Units Operation Manual (W370).
communications. In this case, identify the location of the disconnec-
tion using the disconnection log, and remove the cause of the discon-
nection. For details, refer to information on notification and counter-
measures for network disconnections in the Optical Ring Controller
Link Units Operation Manual (W370).
5-12-2 Displaying the Connection Information Menu
(Network Configuration)
To read, display, save, load and print connect information, select the required
function from the Connection Information (Network Configuration) Menu and
perform the relevant procedure. These procedures are explained over the next
few pages. The method for displaying the Connection Information (Network
Configuration) Menu is given here.
function from the Connection Information (Network Configuration) Menu and
perform the relevant procedure. These procedures are explained over the next
few pages. The method for displaying the Connection Information (Network
Configuration) Menu is given here.
1, 2, 3...
1. Select “K: Connection Information” from the Main Menu. The Connection
Information (Network Configuration) Menu will be displayed.
The Connection Information (Network Configuration) Menu can be dis-
played from a Network Configuration Screen by pressing the F2 (Submenu)
Key.
played from a Network Configuration Screen by pressing the F2 (Submenu)
Key.
5-12-3 Reading Connection Information — R: Read
“R: Read” is used to read and display the connection information for a specified
network.
network.
1, 2, 3...
1. Select “R: Read” from the Connection Information (Network Configuration)
Menu. The following window will be displayed to prompt you to specify the
network to be read.
network to be read.
[Read Network configurations]