Omron SYSMAC C200HW-ZW3AT2-E-V2 用户手册
3-1
Section
Starting and Exiting the Controller Link Support Software
18
3-1-2 Exiting the Software
1, 2, 3...
Press the F1 (Menu) Key to display the Main Menu.
If the Main Menu does not appear when the F1 Key is pressed, press the
Escape Key or F10 (End) Key to terminate the active function, and then
press the F1 Key.
If the Main Menu does not appear when the F1 Key is pressed, press the
Escape Key or F10 (End) Key to terminate the active function, and then
press the F1 Key.
Select
“
Q: Exit to DOS
”
from the Main Menu.
To select
“
Q: Exit to DOS,
”
press
“
Q,
”
or use the Up and Down Cursor Keys
to highlight
“
Q: Exit to DOS
”
and then press the Enter Key.
The Controller Link Support Software will terminate and the system will be
ready to receive the next command as shown below.
ready to receive the next command as shown below.
C:\>
Note a) If the Controller Link Support Software is started from the SYS-
MAC Support Software or Windows, it will return to the original
state when terminated.
state when terminated.
b) If the Controller Link Support Software is started for use with the
Controller Link Support Board, the Controller Link Support Board
will be disconnected from the network when the software termi-
nates. Then, an error indicating that the number of nodes partici-
pating in the network has decreased (error code 0206 Hex) will be
recorded in the error log in the other nodes connected to the net-
work.
will be disconnected from the network when the software termi-
nates. Then, an error indicating that the number of nodes partici-
pating in the network has decreased (error code 0206 Hex) will be
recorded in the error log in the other nodes connected to the net-
work.