Omron SYSMAC C200HW-ZW3AT2-E-V2 用户手册
5-3
Section
L: Data Link
66
5-3-9 Reading Data Link Tables from a File — L: Retrieve Table
“L: Retrieve table” is used to read data link tables from a file into computer
memory.
memory.
With Controller Link Support Software Ver. 2.00, data link tables can be saved in
the file formats shown below.
the file formats shown below.
Format
Extension
Reading supported
Controller Link Support
Software Ver. 2.00
Software Ver. 2.00
.CL2
Yes
Controller Link Support
Software Ver. 1.10
Software Ver. 1.10
.CLK
Yes
CX-Net on
CX-Programmer
CX-Programmer
.CL3
Yes (see note 1)
Note Data link tables in CX-Net format can be read but not saved.
There are differences in PC model information between the Controller Link Sup-
port Software and the CX-Net. Therefore, when reading CX-Net format files with
Controller Link Support Software, the data will be converted in the way shown in
the following table. When performing operations where a high degree of preci-
sion is required, such as when checking data link tables, reset as necessary.
port Software and the CX-Net. Therefore, when reading CX-Net format files with
Controller Link Support Software, the data will be converted in the way shown in
the following table. When performing operations where a high degree of preci-
sion is required, such as when checking data link tables, reset as necessary.
Model information in CX-Net on
CX-Programmer
Model information in Controller LInk
Support Software
No specification
No specification
C200HE
C200HE(-Z)
C200HG
C200HG(-Z)
C200HX
C200HX
CVM1
CVM1-CPU21
CV2000
CV2000
CV1000
CV1000
CV500
CV500
NSB
CLK Board
CS1G
CS1G-45
CS1H
CS1H-67
CVM1-V2
CVM1-CPU21
C200HX-Z
C200HX-85Z
C00HG-Z
C200HG(-Z)
C200HE-Z
C200HE(-Z)
IDSC
No specification
Note
1) If data link tables are read from a file, the current data link tables in the
memory will be lost.
2) If data link tables in the memory have been modified, a confirmation window
will be displayed when you attempt to read data link tables from the file.
3) Data link table files for the Controller Link Support Software are not compat-
ible with those for the SYSMAC LINK Support Utility.
1, 2, 3...
1. Select “L: Retrieve table” from the Data Link Menu. If data link tables in the
memory have been modified, a confirmation window will be displayed.
Press “Y” to continue or press “N” to cancel the process, and then press the
Enter Key. If data link tables in the memory have not been modified or “Y” is
Press “Y” to continue or press “N” to cancel the process, and then press the
Enter Key. If data link tables in the memory have not been modified or “Y” is