Nortel Networks 207344-B 用户手册
Using the Centillion EtherSpeed
II
Switch Modules
3-10
207344-B
5.
Slide the switch module out of the chassis (
).
Hold the front panel with one hand while you support the bottom of the switch
module with the other hand.
module with the other hand.
Figure 3-9.
Removing the Module from the Centillion 50/100 Chassis
6.
Place the switch module on an antistatic mat until you are ready to put it
back into the chassis.
back into the chassis.
7.
If you are not installing another switch module of the same model, install
a filler panel over the empty slot.
a filler panel over the empty slot.
Installing the Replacement Switch Module
To install the replacement switch module, follow the procedure described in
” on
.
Reconfiguring the Replacement Switch Module
The EtherSpeedII 10/100BASE-T and the EtherSpeedII 100BASE-FX switch
modules keep the configuration of an identical replacement module. If the
replacement is not of the same model type, you must reconfigure the module after
it is replaced. Follow the procedure described in
modules keep the configuration of an identical replacement module. If the
replacement is not of the same model type, you must reconfigure the module after
it is replaced. Follow the procedure described in
.
6471