Nlynx ETU400 用户手册

ETU400 User Guide 011603

 

This chapter explains the ETU translation commands. These commands are

used in conjunction with the ETU transfer commands. If, when you transfer

a file, you specify no translation, you will translate it using one of

the commands described in this chapter.

There are four ETU translation command:

•  XLATEFROM--Translates a microcomputer ASCII file to a host physical

file format. This is for use with micro files that were previously

transferred to the host using the TO3XB command with *NONE as the

translation type;

•  XLATETO--Translates a host physical file to ASCII. You can then

transfer the file to the micro using the FROM3XB command with *NONE as

the translation type;

•  PRTXFRMPC--Translates a host print file to a PC print file format

prior to transferring the file with the PRTFROMPC command;

•  PRTXTOPC--Translates a PC print file to a host print file format after

you transfer the file to the host with the PRTTOPC command.

These commands can be run interactively from the micro, or in batch mode

from any micro or host terminal.

The advantages to using the translation commands are described on the

following page. If you are new to ETU, you should read Chapter 4,

Learning About ETU, prior to reading this chapter.