National Instruments NI 1450 Series 用户手册

© National Instruments Corporation

This section describes the sequence for installing the application and driver 
software on the development computer, obtaining an IP address, installing 
software on the NI 1450, and configuring the NI 1450 to acquire an image 
using LabVIEW Real-Time.

This section applies only to LabVIEW Real-Time users. If you are using the 
Vision Builder AI software, refer to the 

 section.

The following items are necessary for setting up the development 
computer.

❑

LabVIEW and LabVIEW Real-Time software

❑

Vision Development Module software

❑

NI-IMAQ for IEEE 1394 Cameras driver software

You must install LabVIEW, LabVIEW Real-Time, and the Vision Development 

Module software before installing the NI-IMAQ for IEEE 1394 Cameras driver software.

Complete the following steps to install LabVIEW, LabVIEW Real-Time, 
the Vision Development Module, and the NI-IMAQ for IEEE 1394 
Cameras software onto the development computer.

1.

Insert the LabVIEW CD into the CD-ROM drive.

2.

When the installation splash screen appears, click Install LabVIEW 
and follow the setup instructions.

3.

Insert the LabVIEW Real-Time CD into the CD-ROM drive.

4.

When the installation splash screen appears, click Install LabVIEW 
Real-Time and follow the setup instructions.

5.

Insert the Vision Development Module CD into the CD-ROM drive.

6.

When the splash screen appears, click Install Vision 7.0 Development 
Module and follow the setup instructions.