National Instruments Car Stereo System 320571-01 用户手册
© National Instruments Corporation
A-1
NI-DSP SRM for LabVIEW for Windows
Appendix A
Error Codes
Error Codes
This appendix contains a list of the error codes returned by the NI-DSP Analysis VIs and the corresponding error
messages.
messages.
Error Conditions
If an error condition occurs during execution of any of the VIs in the NI-DSP Analysis, the VI returns an error code.
This code is a value which indicates the type of error that occurred. The currently defined error codes and their
associated meanings are given in Table A-1. For error codes other than those listed, refer to the NI-DAQ Software
Reference Manual for DOS/Windows/LabWindows.
This code is a value which indicates the type of error that occurred. The currently defined error codes and their
associated meanings are given in Table A-1. For error codes other than those listed, refer to the NI-DAQ Software
Reference Manual for DOS/Windows/LabWindows.
Table A-1. NI-DSP Analysis Library Error Codes
Error
Number
Error Name
Description
0
noError
No error; the call was successful.
-10401
unknownDeviceErr
The board specified is not a National Instruments DSP board.
-10005
badDeviceErr
The board number used in function call should be 1<board<8.
-10403
deviceSupportErr
Function cannot be executed by specified board.
-10444
memFullErr
Insufficient memory or disk space.
-10243
configFileErr
Board configuration file not found.
-10247
cmosConfigErr
EISA system configuration invalid.
-10459
DLLInterfaceErr
The DLL could not be called due to an interface error.
-21204
SamplesGTZero
The number of samples must be greater than zero.
-21205
SamplesGEZero
The number of samples must be greater than or equal to zero.
-21206
SamplesGETwo
The number of samples must be greater than or equal to two.
-21207
SizesGTZero
The sizes of the input sequences must be greater than zero.
-21208
xSizeGEySize
The size of x must be greater than or equal to the size of y.
-21209
OutSizeGEInSize
The output array size must be greater than or equal to the input
array size.
array size.
-21210
OutOfMem
There is not enough space left on the DSP board for onboard
processing.
processing.
-21212
DecFactErr
The decimating factor must meet: 0 < decimating factor
≤
samples.
-21213
WidthLTSamples
The width must meet: 0 < width < samples.
-21214
IndexLTSamples
The index must meet: 0
≤
index < samples.
-21215
DelayGEZero
The delay must be greater than or equal to zero.
-21216
WidthGEZero
The width must be greater than or equal to zero.
-21217
DelayWidthErr
The following condition must be met:
0
0
≤
(delay + width) < samples.
(continues)