National Instruments Car Stereo System 320571-01 用户手册

The NI-DSP software package contains the NI-DSP for LabVIEW for Windows Disks (for licensed LabVIEW for
Windows users).  If your kit is missing any of these components, contact National Instruments.

NI-DSP for LabVIEW for Windows is intended for use with the standard LabVIEW for Windows software.
You must install LabVIEW for Windows before installing NI-DSP.  You must install the Data Acquisition
Library of LabVIEW to run the NI-DSP software.

Before beginning the software installation, make backup copies of the NI-DSP for LabVIEW for Windows
distribution disks.  Copy each disk onto a correctly labeled backup disk and store the original distribution disks in a
safe place.

You can install NI-DSP for LabVIEW for Windows from the DOS prompt, the Windows File Manager, or with the
Run... command from the File menu of the Program Manager.

1.

Insert Disk 1 into the disk drive and run the 

SETUP.EXE

 program on Disk 1 using one of the following three

methods.

•

From the DOS prompt, type 

X: \SETUP

 (where X is the proper drive designation).

•

From Windows, select Run... from the File menu of the Program Manager.  A dialog box appears.  Type

X: \SETUP

 (where X is the proper drive designation).

•

From Windows, launch the File Manager.  Click on the drive icon that contains Disk 1.  Find 

SETUP.EXE

in the list of files on that disk and double-click on it.

2.

The installer gives you the option of performing a full installation or a custom installation.  Unless you do not
have sufficient disk space (approximately 4 megabytes), National Instruments recommends that you perform a
full installation.  After you choose an installation, follow the instructions that appear on the screen.

After calling 

SETUP

, the appropriate directories are created and the needed files are copied to your hard drive.

SETUP

 can also install the NI-DSP Interface Utilities, discussed in Part 4, NI-DSP Interface Utilities, of this manual.

If you choose Full Installation, 

SETUP

 does the following things:

1.

SETUP

 creates a subdirectory called 

DSP2200

 of the 

vi.lib

 subdirectory of the 

LabVIEW

 directory.

SETUP

 decompresses the NI-DSP Analysis VIs (as LabVIEW 

.LLB

 files) in the 

DSP2200

 directory.

2.

SETUP

 copies 

DSP.DLL

 to your 

windows

 directory.

3.

SETUP

 creates the subdirectories shown in Table 1-1 under the directory you specified during setup.  These

subdirectories make up the NI-DSP Interface Utilities.

4.

SETUP

 creates a subdirectory called 

DSP2200

 of the 

EXAMPLES

 subdirectory of the 

LabVIEW

 directory.

SETUP

 copies all of the NI-DSP VI examples there.

Table 1-1.  Subdirectories Created by 

SETUP

C:\NIDSP\LIB

Library files for linking with stand-alone programs

C:\NIDSP\DISPATCH

The Dispatch utility and related files

C:\NIDSP\EXAMPLES

Contains source code for the examples