KVH Industries TracVision M5 用户手册

17

Follow these steps to set up the system for the 
desired pair of satellites.

a. Press the center MENU button on the MCP’s 

front panel to access the onscreen menu (see 

b. At “Install Satellite?”, press YES.

c. At “Trisat Mode?”, press NO.

d. At “Install A <SAT NAME>”, press NEXT 

until the display shows the first (primary) 

satellite you want to select. Then press YES. 

(See Appendix D on page 30 for a list of 

available satellites.)

e. Repeat Step 15d to select the second satellite. 

If you want to set up the antenna to track just 

one satellite, select “None” instead.

f. Wait two minutes while the antenna restarts.

g. (Linear only) Set up the receiver(s) for the 

same satellites, and in the same order, that 

you set them up in the antenna:

Sat. A

Alternative 1 or A

DiSEqC 1

Sat. B

Alternative 2 or B

DiSEqC 2

To select a three-satellite (Trisat) group for a 

linear system, see Appendix C on page 29. To 

select a DIRECTV HDTV three-satellite 

(Trisat) group, see Appendix A on page 23. 

Press NEXT until desired satellite shown

Press NEXT until desired satellite shown

Figure 35:  Satellite Selection Menus on MCP

Select Satellites

15