KVH Industries TracVision M5 用户手册

25

4. Connect an RF coax cable from the “RF Out” 

jack on the HDTV converter to the “LHCP 

+18V” jack on the multiswitch.

5. Connect an RF coax cable from the “Tone 

Detect” jack on the MCP to either of the 

“Out” jacks on the splitter.

6. Connect an RF coax cable from any output of 

the multiswitch to the available “Out” jack on 

the splitter.

7. Connect an RF coax cable from the “Input” 

jack on the splitter to the “Satellite In” jack on 

the primary HD receiver. This receiver will 

control satellite selection.

8. Connect any additional HD or standard 

receivers to the available outputs of the 
multiswitch.

9. Terminate any unused multiswitch outputs 

with 75 ohm DC blocks (Channel Master 
#7184, Radio Shack #15-1259, or equivalent).

10. Follow the instructions in Steps 12 and 13 on 

pages 14-15 to connect power and mount the 

switchplate and MCP. Then skip to page 26 to 

select satellites.

The receiver you connected to the splitter is 

the primary receiver that controls satellite 

selection. The secondary receiver(s) will only 

be able to select a channel on the satellite that 

is currently selected on the primary receiver. 

Be sure the multiswitch is properly grounded. 

With the multiswitch grounded, you do not 

need to ground the individual receivers.

Continued...

A