KVH Industries TracVision M5 用户手册

6

Once you have identified suitable mounting sites 
for the switchplate and MCP, follow these steps 
to prepare the sites for installation.

Switchplate

a. Using the switchplate mounting template 

provided at the end of this manual, mark and 

cut out a hole in the mounting surface to 

accommodate the switchplate (see Figure 7). 

b. Using the same template, mark the locations 

for the four switchplate mounting holes. 

c. Drill a 3/32" (2.25 mm) hole at the four 

mounting hole locations. Later, you will 

mount the switchplate using four #6 screws.

MCP (Flush Mount only)

a. Attach the supplied flush mount bracket to 

the MCP now, before you connect any cables. 

Simply slide the bracket onto the MCP from 

behind and position the front edge of the 

bracket over the seam line between the front 

bezel and the chassis. Secure the bracket in 

place using two #6-32 screws and washers 

b. Using the MCP flush mounting template 

provided at the end of this manual, mark and 

cut out a hole in the mounting surface to 

accommodate the flush mount bracket (see 

Figure 9).

c. Using the same template, mark the locations 

for the four MCP mounting holes.

d. Using a #29 drill bit, drill a 0.136" (3.45 mm) 

hole at the four mounting hole locations. 

Later, you will mount the MCP using four #8 

screws.

  3/32" (  2.25 mm)
Mounting Hole (x4)

3.82"

(97 mm)

.32" (8 mm)

2.36"

(60 mm)

.16" (4 mm)

3.19"

(81 mm)

2.05"

(52 mm)

Panel Cutout

Figure 7:  Switchplate Mounting Holes Layout

#6-32 x 1/2" Screw 
and Washer (x2)

Figure 8:  MCP Flush Mount Bracket

8.87"

(225 mm)

7.62"

(194 mm)

.63"

(16 mm)

3.08"

(78 mm)

1.83"

(46 mm)

.63"

(16 mm)

  .136" (  3.45 mm)
Mounting Hole (x4)

Figure 9:  MCP Mounting Holes Layout

Prepare the Belowdecks Sites

4