K2 Mounts K2 Series K2-A3-S 用户手册

3

www.k2mounts.com

Installation

To mount to a wood stud wall, continue below.  To mount to a concrete wall, go to page 4.

Wood Stud Wall Installation

Locate the Wall Studs
Wall studs run vertically (up and down) inside the wall, behind the drywall or plaster.  You must

attach the mounting plate to two separate wall studs that run from floor to ceiling.  This mount 

requires that the wall studs be 16 inches apart (on center).  

1. Using the stud finder, mark the left and right edges of the 

studs closest to where you want to mount the screen.

2. Mark the centerline of each stud. 

Drill Mounting Holes
. If you have the installation poster:

a. Tape the poster to the wall with the ACTUAL SIZE

TEMPLATE side showing. Line up the mounting holes with

the centers of the wall studs.  Level the Articulating Arm/

Wall Mounting Plate.

b. Drill where indicated with a 3/16” drill bit, 2 1/2” deep.    

a. Hold the Articulating Arm/Wall Mounting Plate up to

the wall, lining up the left-most and right-most mounting 

holes and with the centers of the wall studs.  Level the 

Articulating Arm/Wall Mounting Plate.

b. Make marks on the wall through all the left-most and right-most holes and then remove the 

Articulating Arm/Wall Mounting Plate from the wall.  

c. Drill five holes at the marks with a 3/16” drill bit, 2 1/2” deep.    

Anchor Articulating Arm/Wall Mounting Plate to the Wall 
1. Using the ratchet and 7/16 inch socket, anchor the Articulating 

Arm/Wall Mounting Plate to the wall with five of the 7/16” x 

2” Lag Bolts and Washers from the Wall Hardware bag.

2. Go to “Attach the Screen Plate to the Screen” section on page 5.