Jettech Metal Products X-32 用户手册
DRAIN
The X‐32 is equipped with an automatic drain pump that will pump the drain
water to a maximum height of 36" (0.9 meter). A 1" ID flexible drain hose is
included to facilitate maintenance and servicing of the machine. It is important
not to reduce the size of this hose. The drain should have a loop at the back of
the dishwasher as per illustration below. The loop should be 36 inches (36”)
above the floor and drop down into a drain pipe with an air gap. These
instructions must be followed for proper dishwasher operation. It is normal for
some water to remain in the wash tank after draining.
water to a maximum height of 36" (0.9 meter). A 1" ID flexible drain hose is
included to facilitate maintenance and servicing of the machine. It is important
not to reduce the size of this hose. The drain should have a loop at the back of
the dishwasher as per illustration below. The loop should be 36 inches (36”)
above the floor and drop down into a drain pipe with an air gap. These
instructions must be followed for proper dishwasher operation. It is normal for
some water to remain in the wash tank after draining.
WATER INLET
A 3/4” NPT coupling is required with a maximum of 20 p.s.i. dynamic pressure,
and a minimum of 18 p.s.i. . A water pressure regulator is required. The water
pressure should be 20 p.s.i. Incoming water temperature must be 140º F ( 60º
C). An easily accessible shut‐off valve is recommended ‐‐‐ making installation,
service and repairs easier.
Flexible hoses must be used to make installation, servicing and maintenance
easier.
Make sure that the water is free from calcium and hard water deposits. Water
with a mineral contain of 6 grains or higher must have an on‐line water filtering
system or some other type of water softening system. Build‐up of calcium and
lime deposits in the washer may occur and servicing will be required on
a more frequent basis which will not be covered by the warranty.
and a minimum of 18 p.s.i. . A water pressure regulator is required. The water
pressure should be 20 p.s.i. Incoming water temperature must be 140º F ( 60º
C). An easily accessible shut‐off valve is recommended ‐‐‐ making installation,
service and repairs easier.
Flexible hoses must be used to make installation, servicing and maintenance
easier.
Make sure that the water is free from calcium and hard water deposits. Water
with a mineral contain of 6 grains or higher must have an on‐line water filtering
system or some other type of water softening system. Build‐up of calcium and
lime deposits in the washer may occur and servicing will be required on
a more frequent basis which will not be covered by the warranty.