JAI TM-1020 用户手册

The printed circuit boards in the TM-1020 series have been arranged based on a new design 

philosophy. This creates modular electronics for the camera, giving it flexibility. In addition, the 
use of miniature solid-state components results in a compact, lightweight camera that is 44mm x 
44mm x 64mm in dimensions, and weighs only 149 grams. 

The TM-1020 series uses a progressive-scan interline transfer CCD that has the following features:

Resolution of 1008 x 1018 active pixels for excellent image quality.

9.0 x 9.0 µm square pixels for precise dimensional measurement.

High-speed electronic shutter capability for high dynamic resolution of moving objects and 

electronic iris control that eliminates the need for a mechanical shutter.

Progressive-scan CCD eliminates interlace deterioration of image and increases ease of 

computer interface.

High sensitivity and low noise at fast scanning. The 1” CCD has an excellent S/N ratio that 

is greater than 50dB.

The CCD has a built-in microlens for increased quantum efficiency.

The TM-1020 series has a substrate drain-type shutter mechanism which provides superb pictures 

at various speeds without smearing. A built-in manual shutter speed control selects the electronic 
shutter rate of 1/60 (non-async mode only), 1/125, 1/250, 1/500, 1/1,000, 1/2,000, 1/4,000, 1/8,000, 
or 1/16,000 second.

With VINIT high (5V), the CCD keeps discharging. With a negative pulse to VINIT, the camera 

resets and purges the charge momentarily. Then it starts integrating for the period of shutter control 
set by either an external pulse width or internal shutter control. Progressive scanning permits a full 
1000 lines of vertical resolution, as compared to a conventional CCD camera which captures only 
half the vertical lines per shutter.

The TM-1020 series captures async reset images and provides single-shot video output with single 

FDV. This makes it simpler for an ordinary frame grabber to capture the async reset images. The 
TM-1020 series’s asynchronous reset is flexible and accepts external horizontal drive (HD) for 
phase locking. When the VINIT (5V) pulse is applied, it resets the camera's scanning and purging 
of the CCD. 

The TM-1020A-15 has two modes to control the asynchronous reset and shutter speed:

External VINIT with pulse width. The duration between pulse edges controls the shutter 

speed externally (No-delay shutter).

Internal shutter speed control. The speed control varies from 1/125 to 1/16,000 sec. The 

video signal and FDV starts with internal V reset timing related to shutter speed. 

The TM-1020-15 has three modes to control the asynchronous reset and shutter speed:

External VINIT with pulse width. The duration between pulse edges controls the shutter 

speed externally.

Internal shutter speed with Fast mode. The video signal has no delay from the reset tim-

ing. (shutter speed range is 1/2,000 to 1/16,000 sec.)