JAI TM-1020 用户手册

The TM-1020 series camera requires 12V DC power that is obtained through the 12-pin connector 
located on the rear panel of the camera. JAI, Inc. recommends the following power supplies:

PD-12UU

100-240V AC/12V DC

1.2A universal voltage power supply,

(No 12-pin connector)

US Plug

PD-12UUP

PD-12UU with12-pin connector 

US plug

PD-12UE

PD-12UU

European plug

(No 12-pin connector)

PD-12UEP

PD-12UU with 12-pin connector

European plug

For users providing power through the 12-pin connector, the PD-12P, PD-12UEP and PD-12UUP 
power supplies are available with the 12-pin mating connector already attached to the leads from the 
power supply. The PD-12UU and PD-12UE power supplies can be connected to the JAI, Inc. power 
cable via a terminal strip or directly. 

When wiring the PD-12UU and PD-12UE power supplies directly, please note the following:

The lead ends must be twisted together and tin-soldered for strength and electrical continuity. 

Shrink tubing or a similar insulator should be used to prevent exposed leads from touching and 

shorting. 

The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads. 

All connections must be properly insulated to prevent shorting. 

If you are using JAI, Inc. power cables such as the 12P-02S, please refer to the 12-pin connector pin-out 
diagram in “12-Pin Connector (LVDS/RS-422 version)” on page 6. The cable pin-out diagram is shown 
in Figure 8 below. The color-coded leads use Gray for Ground and Yellow for +12V.