Multitech PROXYSERVER MTPSR1-120 用户手册
15
Chapter 2 - Installation
Table 2-1. (cont’d.)
Step
Procedure
5.
If a cable modem, DSL modem, or your Internet LAN is being used, no cable connection
will be made to the RS232/V.35 connector on the back of the ProxyServer.
will be made to the RS232/V.35 connector on the back of the ProxyServer.
If the RS232/V.35 connector on the ProxyServer is going to be connected to a WAN
device (i.e., connecting your secure (private) LAN to an ISP, connect one end of an
RS232 or V.35 interface cable to the RS232/V.35 connector on the back of the
ProxyServer. Connect the other end of this cable to the WAN device.
device (i.e., connecting your secure (private) LAN to an ISP, connect one end of an
RS232 or V.35 interface cable to the RS232/V.35 connector on the back of the
ProxyServer. Connect the other end of this cable to the WAN device.
6.
Turn on power to the ProxyServer by placing the ON/OFF switch on the back panel to
the ON position. Wait for the Fail LED on the ProxyServer to go OFF before proceeding.
This may take a couple of minutes to go OFF.
the ON position. Wait for the Fail LED on the ProxyServer to go OFF before proceeding.
This may take a couple of minutes to go OFF.
At this time your ProxyServer is completely cabled. Proceed to
to load the Firewall
software.