Multiquip GB2000 用户手册
gb2000 balloon lighT• operaTion and parTs manual — rev. #3 (08/30/12)— page 23
type 2 setup (s/n G1900119 and abOve)
preparaTion
1. Place the light tower in an area free of dirt and debris
with enough clearance as not to interfere with any
overhead obstructions. Make sure it is on secure level
ground with chock blocks underneath each wheel to
prevent the light tower from rolling.
2. If the light tower is in the deployed position, place the
tower mast into the cradle support (stowed position).
See Figure 15. Make sure cradle lock/release pin has
been inserted and the mast is locked.
Figure 15. Light Tower in Stowed Position
danger
alWays make sure the area above
light tower is open and clear of
overhead power lines and other
obstructions. The tower extends in
excess of 30 ft. (9 meters). Contact
with overhead power lines or other
obstructions could result in equipment
damage, serious injury or death!
STOWED
POSITION
MAST
LOCK
NOTICE
The new lamp adapter plate requires no existing lamp
removal for installation. All lamps can remain in place
during installation of the adapter plate.
poWer disConneCTion
1. For LT12D light towers, disconnect the negative cable
(black) from battery. See Figure 6.
Figure 16. Disconnecting Battery
2. For MLT series light towers disconnect the 4-pin
power cable (Figure 17) from the 120 VAC twist-lock
receptacle on the front panel of the generator.
Figure 17. MLT Power Cable Removal
DISCONNECT
NEGATIVE
BATTERY CABLE
IDLE CONTROL
0
0
0
0
0
HOURS
ON
OFF
WHISPERW
ATT
7KW AC
Model DA-7000SS
Model DA-7000SS
7000 WATT
DIESEL POW
ERED AC GEN
ERATOR
STARTER SWITCH
RUN
HEAT
START
STOP
HOUR METER
AC VOLTMET
ER
AC CIRCUIT
BREAKER
120/240V
25A
25A
120V
20A
25A
MLT
LIGHT TOWER
TO BALLAST
COMPARTMENT
4-PIN POWER
CABLE
DISCONNECT