Motorola GT10 用户手册
GT10/GT30
2.1
Installation
19
2.1.3
GT30 Installation Method
Secure the GT30 to the installation panel using the two fittings and four screws provided
with the unit.
with the unit.
(1) Place the GT30 main unit in the installation panel.
(2) Insert the fittings into the grooves provided in the GT30 main unit, and tighten
the screws to secure the GT30 main unit to the installation panel.
the screws to secure the GT30 main unit to the installation panel.
Installation panel
Attachment screws
Attachment fittings
Slits (located all the way around the periphery)
CAUTION
Screw tightening torque
The screw tightening torque should be 0.1 N m to 0.25 N m.
Tightening the screws too hard can cause deformation of the front
panel , so that the switch will not function properly. Make sure
screws are tightened to the appropriate degree.
The screw tightening torque should be 0.1 N m to 0.25 N m.
Tightening the screws too hard can cause deformation of the front
panel , so that the switch will not function properly. Make sure
screws are tightened to the appropriate degree.
Applicable panel thickness
A panel with a thickness of 1.0 mm to 5.0 mm should be used.
A panel with a thickness of 1.0 mm to 5.0 mm should be used.
Installation angle and ambient temperature range for usage
If the unit is being installed in a horizontal orientation and the
Matsushita Programmer II and C–NET adaptor are being connected
to the Tool port, please be aware that the ambient usage
temperature should not exceed 40
If the unit is being installed in a horizontal orientation and the
Matsushita Programmer II and C–NET adaptor are being connected
to the Tool port, please be aware that the ambient usage
temperature should not exceed 40
°
C/104
°
F.
Liquid display panel side
(Horizontal installation)
Installation panel
Clearance when the GT30 s installed
When installing the GT30, if other parts are being installed to the
panel or cables are being wired to it, we recommend providing a
When installing the GT30, if other parts are being installed to the
panel or cables are being wired to it, we recommend providing a