MiTAC 8170 用户手册
162
8170 N/B MAINTENANCE
Hard Driver
Test Error
Yes
No
Re-boot
OK?
Replace the faulty parts.
1. Check if BIOS setup is OK?.
2. Try another working drive and cable.
2. Try another working drive and cable.
Check the system driver for proper
installation.
installation.
No
Re - Test
OK?
End
Yes
Replace
Motherboard
One of the following parts or signals on the motherboard may be
defective, use an oscilloscope to check the signals or replace the parts
one at a time and test after each replacement.
defective, use an oscilloscope to check the signals or replace the parts
one at a time and test after each replacement.
PARTS:
SIGNALS:
U17 R138
Q13 Q14
R137 C201
C182 R84
R91 R71
R156 J21
Q13 Q14
R137 C201
C182 R84
R91 R71
R156 J21
-HDDRST -PDACK
PDA1
PDA0
PIORDY PDERQ
-PDIOW
-PDIOR
IRQ14
-PCS1
-PCS3
PDA
PDD[0:15]
-HDD_PWRON
Board-level
Troubleshooting
8.8
Hard Drive Test Error
Either an error message is shown, or the driver motor continues spinning, while reading data is from or
writing data is to hard drive.
writing data is to hard drive.